Increase this value if the simulation is generating too many polygon edges.

The solver will attempt to reconnect filaments with approximately anti-parallel edges, as the effects of such edges approximately cancel out. This can prevent the number of polygon edges from increasing exponentially during the simulation. Increasing this value will cause filaments to be reconnected more aggressively.

Remove any edges shorter than this length by collapsing those edges to their center point.

Subdivide any filament edges that are longer than this length.

Turn this on to limit the speed of the filament vertices. Set the speed limit in the Speed Cap parameter.

The maximum speed of a filament vertex (when Cap Speed is on).

An overall scale applied to the actual timestep. You can animate this value.

The name of the simulation data that contains the vortex filament geometry.

All objects connected to the first input of this node become mutual affectors.

This is equivalent to using an Affector DOP to create an affector relationship between * and * before connecting it to this node. This option makes it convenient to have all objects feeding into a solver node affect each other.

When an object connector is attached to the first input of this node, this parameter can be used to choose a subset of those objects to be affected by this node.

Indicates the name that should be used to attach the data to an object or other piece of data. If the Data Name contains a "/" (or several), that indicates traversing inside subdata.

For example, if the Fan Force DOP has the default Data Name "Forces/Fan". This attaches the data with the name "Fan" to an existing piece of data named "Forces". If no data named "Forces" exists, a simple piece of container data is created to hold the "Fan" subdata.

Different pieces of data have different requirements on what names should be used for them. Except in very rare situations, the default value should be used. Some exceptions are described with particular pieces of data or with solvers that make use of some particular type of data.

Turning on this parameter modifies the Data Name parameter value to ensure that the data created by this node is attached with a unique name so it will not overwrite any existing data.

With this parameter turned off, attaching two pieces of data with the same name will cause the second one to replace the first. There are situations where each type of behavior is desirable.

If an object needs to have several Fan Forces blowing on it, it is much easier to use the Unique Data Name feature to ensure that each fan does not overwrite a previous fan rather than trying to change the Data Name of each fan individually to avoid conflicts.

On the other hand, if an object is known to have RBD State data already attached to it, leaving this option turned off will allow some new RBD State data to overwrite the existing data.